Wireless Geiger Counter - Trouble Obtaining Data

Trouble Obtaining Geiger Counting Data

Trouble Obtaining Data

Customer having trouble with obtaining proper counts:

Try:  Leave the voltage on the default 500V, it should be the optimal voltage for reading the counts. 

*******************************************************************************************************************

Customer having trouble with saving Data, after setting the start and end conditions to count for a fixed time.

Cause: This is an indication that the Start Condition was never met. In that case, no run is recorded.

If you want to count for a specific amount of time, display Count Rate (counts/sample) and set the Sample Rate on the Sampling Bar at the bottom of the screen to 30 seconds (as an example). Then the total counts for 30 seconds will be displayed after 30 seconds and then the total counts for the next 30 seconds will be displayed after 60 seconds, etc.

If you only want to sample for 30 seconds and then stop, open the Geiger Counter Tool at the left and check the box for “Record only one interval”.