Bend Testing Beams
In this lab, a Three-Point Bend Test is performed on the ABS plastic beams included with the PASCO Structures System. Then, the Flexural Elastic Modulus...
Tensile Testing Beams
In this lab, a Tensile Test is performed on plastic beams and Young's Modulus is measured. Students test beams with varying cross-sectional shapes to investigate...
Column Buckling and Slenderness Ratio
In this lab, three different lengths of plastic I-beams are tested under compression to investigate...
Euler Column Buckling
The Euler Column Equation predicts the maximum compressional force applied to a column before it buckles. This value depends on the length of the column,...
Column Buckling Tensile Samples
The Euler Column Equation predicts the maximum compressional force applied to a column before it buckles. This value depends on the length of the column,...
Compression Testing Cast Beams
In this lab, Plaster of Paris cast beams are tested to destruction using compression. Quantities measured include Young's Modulus and the Compressive Strength...
Bend Testing Cast Beams
In this lab, a three-point bend test is performed on Plaster of Paris cast beams and the Flexural Elastic Modulus for the material is calculated. The maximum...
Shear Testing Round Rods
In this lab, a single-shear test is performed on 1/8 inch diameter metal rods. The maximum force needed to shear the rod is measured and used to calculate...
Strength of Materials
This lab investigates two ways in which a member can fail: In tension and in shear. A standard tensile test is performed using the Tensile Samples, and...
Photoelasticity
Photoelasticity is used to determine the stress distribution in birefringent plastics, such as polycarbonate. This experiment uses the clear polycarbonate...
Copyright Disclaimer: Section 107 of the Copyright Act of 1976 makes allowance for “fair use” for purposes of teaching, scholarship, education and research. Reproduction under any other circumstances, without the written consent of PASCO, is prohibited.